Extron electronics DTP CrossPoint 4K Series User Manual page 119

Expansion port input signal gain control (see
AM block — The automixer block, when inserted, manages multiple input sources,
gating or varying input gain automatically, to improve the performance when multiple
inputs are in use. The automixer block is identical to as described for the Mic/line Inputs
AM block on page 108.
Gain control — The always-present expansion port input pre-mixer gain control
provides a fader with a gain range of 12 dB to -100 dB, adjustable in 0.1 dB
increments. The Gain block is identical to as described for the Mic/line inputs signals
block
on page 101.
Post-matrix signal processor chain (see
The post-matrix signal processor chain makes adjustments to program audio material, after
it is tied to a specific output but before it is mixed with microphone or other audio material.
Filter block — The filter processor block, when first inserted, provides
one of ten filter selections; additional filters can be then be added. The
available filters and the process for adding additional filters are as
described for the Line audio
NOTE: Selecting
Bass & Treble Filter
Gain (pre-mixer) control block — The always-present gain control
provides left and right channel controls to adjust the audio level of each
audio output from the AV switcher block through a range of -100 dB to +12
dB to ensure that there is no noticeable volume difference among sources.
Click and drag the desired fader (
value.
3
Mute buttons — Click to separately silence and unmute
unmute the left and right audio channels. If you mute both
channels, audio is completely silent on that output. When one
or both channels are muted, one or two red indicators in the block turn
on.
NOTE: When the left and right channels are ganged, either
button mutes and unmutes both channels.
4 Gang button — Click to tie the left and right fader controls together.
Ganged faders move together at relative levels to the top or bottom of their
travel. If one fader reaches the limit of its travel first, it retains that position
while the other fader continues to travel. When the ganged faders travel in the reverse
direction, the fader that was at its limit reverts to its position relative to the other fader.
NOTES:
• The indicator (
this example) (see
• Multiple masters can be created for a fader, in which case the
• By default, the front panel Volume knob controls this fader.
DTP CrossPoint 4K Series Matrix Switchers • Matrix Software
figure 53
Filter block on page 103.
inserts two separate filters.
) or click in the dB field (
1
) means that this fader is part of a group master (group 1 in
5
Group masters on page 119 to create group masters).
figure 53 on page 97,
E
, )
F
1 1 1 1 1 1 1 1 1 1
) and enter a
2
5 5 5 5 5 5 5 5 5 5
2 2 2 2 2 2 2 2 2 2
4 4 4 4 4 4 4 4 4 4
Mute
indicator is
5
)
Gain
1 1 1 1 1 1 1 1 1 1
5 5 5 5 5 5 5 5 5 5
2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3
.
111