Dsp Configurator Windows Menus - Extron electronics DTP CrossPoint 4K Series User Manual

7. Clicked
live to the switcher, completing the mode selection. Ties, processors, and presets are
pushed or pulled as selected.
8. If you have created ties or made any changes to the DSP parameters (including gain
and processor blocks) since the last time you saved to a file, the DSP Configurator
prompts you to save the file. Click
If a password was required and not entered or if an incorrect password was entered,
the program prompts for the password.

DSP Configurator Windows Menus

DSP Configurator File menu
NOTE:
New — Discards the current DSP configuration (after prompting to
save any changes) and opens a blank configuration file with no inserted
processors, saved presets, created ties, or mic mixes.
Open — Loads and activates a previously saved DSP configuration file.
Save — Saves all changes to the current DSP configuration file under the
current file name. If the file has not previously been saved the program
prompts for a file name.
Save As — Saves all changes to the current DSP configuration file under a new file name.
Backup — Transfers all presets plus the current configuration to a DSP configuration file
within the DSP Configurator program.
Recent Files — Opens a list of recently opened or saved DSP configuration files, making
it easy to select one to open.
Exit — Closes the DSP Configurator Program.
DSP Configurator Edit menu
Cut — Copies all of the parameters of a selected processor block or
set of selected blocks to the clipboard and removes the blocks from the
processor stream.
NOTES:
• Gain blocks are always present and cannot be
• Processor blocks are removed from the processor stream after a
subsequent
• Processor blocks and their parameters can be pasted only into another block of
the same type. For example, the input 1 filter block and all of its parameters can be
copied to the input 2 filter block but not to the input 1 delay block.
Copy — Copies all of the parameters of a selected processor block, gain block, or set of
selected blocks to the clipboard.
Paste — Inserts processor blocks and their parameters from the clipboard into the
DSP Configurator program at the location selected.
in step 6c — Click
All
, , and
New Open Recent Files
operation.
Paste
DTP CrossPoint 4K Series Matrix Switchers • Matrix Software
( ). The DSP Configurator program is connected
OK 8
or ( ), as desired.
Yes No £
are unavailable in Live mode.
.
Cut
and a
Cut
129