Extron electronics DTP CrossPoint 4K Series User Manual page 17

Auto Input Memory — When activated for an input delivered to the scaled (HDMI and
•
DTP) outputs, the unit automatically stores size, position, and picture settings based on
the incoming signal. When the same signal is detected again, these image settings are
automatically recalled from memory.
• Output Standby Mode — The unit can be set to automatically mute video and sync
output to the display device when no active input signal is detected. This allows the
projector or flat-panel display to automatically enter into standby mode to save energy
and enhance lamp or panel life.
User presets — Presets are available for each input to store and recall optimized
•
image settings.
Internal video test patterns for calibration and setup — The unit offers several test
•
patterns for the scaled (HDMI and DTP) outputs, to facilitate proper system setup and
calibration of display devices.
Automatic input cable equalization, up to 100 feet (30 meters), at 1080p at
•
60 Hz, with 8-bit color when used with Extron HDMI Pro Series cable — Actively
conditions incoming HDMI signals to compensate for signal loss when using long cables
or source devices with poor HDMI signal output. 4K at 30 Hz, and 2560x1600 at 60 Hz
resolutions are equalized to 50 feet (15 meters). Improves performance when using low
quality cables.
• Automatic HDMI output reclocking — Reshapes and restores timing of digital
video signals at each HDMI output, eliminating high frequency jitter to ensure reliable
transmission over long cables.
• Remote power — Provides +5 VDC, 250 mA power on each HDMI output for
powering external peripheral devices, such as the Extron DVI 104. Power provided
via an HDMI output eliminates the need of a separate power supply for the connected
peripheral device.
Front panel security lockout — Prevents unauthorized use in non-secure
•
environments. In lockout mode, a special button combination is required to operate the
matrix switcher from the front panel controller.
Ethernet monitoring and control — Enables control and proactive monitoring over a
•
LAN, WAN, or the Internet. An intuitive Web interface is included for basic configuration
of the unit.
Built-in Web pages — Enables the use of a standard browser for device monitoring
•
and troubleshooting over an intuitive Web interface.
RS-232 control port — Enables the use of serial commands for integration into
•
a control system. Extron products use the SIS - Simple Instruction Set command
protocol, a set of basic ASCII commands that allow for quick and easy programming.
Front panel USB configuration port — Enables easy configuration without having to
•
access the rear panel.
• RJ-45 signal and link LED indicators for DTP ports — Provides a means for
validating signal flow and operation, allowing quick identification of connectivity issues.
• Easy setup and commissioning with the Extron Product Configuration Software
(PCS) — Conveniently configure multiple products using a single software application.
• Rack-mountable 3U or 2U, full rack width metal enclosure
• Includes LockIt HDMI cable lacing brackets
DTP CrossPoint 4K Series Matrix Switchers • Introduction 9