Table of Contents
Advertisement
Valid addresses consist of four 1-, 2-, or 3-digit numeric subfields, properly called
octets, separated by dots (periods). Each field can be numbered from 000 through 255.
Leading zeroes, up to 3 digits total per octet, are optional. Values of 256 and above are
invalid. For more information on all of these fields, see the IPCP Pro Series User Guide at
www.extron.com.
The default addresses are as follows, but if these conflict with other equipment at your
installation, you can change the addresses to any valid value:
•
•
The
switcher and cannot be changed.
Edit any of these changeable fields as follows:
NOTE: The address fields cannot be edited when DHCP is selected.
1.
2.
3.
4.
Use DHCP Check box
The
and to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if
the network is DHCP capable). Contact the local system administrator to determine if this
is the appropriate selection. Click the
affect.
Update the Firmware
Click the
Update
the switcher without removing it from the system.
Figure 85.
Update the switcher firmware as follows:
1.
2.
3.
4.
5.
IP address
192.168.254.254
Subnet mask
255.255.0.0
(see
figure 84
MAC Address
Click in the desired field. The graphic cursor becomes a text cursor.
Edit the address or name as desired.
Press the <Tab> key on the keyboard or click in another field to exit the field.
Click the
button (
) to make the address change take affect.
Apply
7
check box (
) directs the matrix switcher to ignore any entered IP addresses
6
Use DHCP
button in the
Update
Device Info
dialog box. The dialog box provides a way to replace the firmware that is coded in
1 1 1 1
1 1 1 1
1 1
Firmware Update Dialog Box
Perform steps 1 through 6 of
firmware upgrade from the Extron website.
Connect the PC to the matrix switcher via any switcher LAN port.
Access the matrix switcher using HTML pages.
Click
in the
Update
Device Info
dialog box opens.
Click
(
). The
2
Browse
Open
DTP CrossPoint 4K Series Matrix Switchers • HTML Pages
•
Gateway address
on the previous page,
) is hardcoded in the matrix
5
button (
) to make check box changes take
7
Apply
panel (see figure 85) to open the
Installing the Software
on page 86, to download the
panel (see figure 85,
1
dialog box opens (see
figure 86
0.0.0.0
Firmware
2 2 2 2
2 2 2 2
2 2
). The
Firmware Upgrade
on the next page).
156
Hide quick links:
Advertisement
Table of Contents
