Host-To-Switcher Instructions; Switcher-Initiated Messages - Extron electronics DTP CrossPoint 4K Series User Manual

Host-to-Switcher Instructions

The switcher accepts SIS (Simple Instruction Set) commands through the rear panel
Remote RS-232 port, the front panel Configuration port, and the rear panel Ethernet
(LAN) port. SIS commands consist of one or more characters per command field. They
do not require any special characters to begin or end the command character sequence.
Each switcher response to an SIS command ends with a carriage return and a line feed
(CR/LF =
more characters.

Switcher-Initiated Messages

When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
The switcher does not expect a response from the host, but, for example, the host program
might request a new status.
(c) Copyright 20yy, Extron Electronics, DTPCPxx, Vx.xx, 60-nnnn-nn
{day, date, time}
The switcher initiates the
powered up and on a newly connected Internet protocol (IP) port.
name,
Password:
The switcher initiates the
when the controlling system is connected using TCP/IP or Telnet and the switcher is
password protected. This message means that the switcher requires an administrator or
user level password before it will perform the commands entered via this link. The switcher
repeats the password message response for every entry other than a valid password until a
valid password is entered.
]
]
The switcher initiates the
has been entered. If the user and administrator passwords are the same, the switcher
defaults to administrator privileges.
Qik
The switcher initiates the
Rprnn
The switcher initiates the
front panel. "
GrpmDn*y
The switcher initiates the
the control:
Exen
The switcher initiates the
mode) is toggled on or off from the front panel. "
Setting the Front Panel Locks (Executive Modes)
the Lock modes.
), which signals the end of the response character string. A string is one or
]
]
Copyright
is the firmware version number, and
Vx.xx
]
Password
]
Login Administrator
]
Login User
Login
]
message when a front panel tie creation has occurred.
Qik
]
message when a memory preset has been recalled from the
Rpr
" is the preset number.
nn
]
Grpm
(Volume) or (Mic Volume). "
1 2
]
message when the front panel security lockout (executive
Exe
DTP CrossPoint 4K Series Matrix Switchers • Programming Guide
message on the Remote RS-232 port when it is first
60-nnnn-nn
message immediately after the copyright message
message when a correct administrator or user password
message when a front panel Volume knob is adjusted. "
" is the variable.
y
" is the executive mode:
n
on page 48 for more information on
]
is the model
DTPCPxx
is the switcher part number.
" is
n
, , or . See
0 1 2
66