These switches tailor the TP output signals as follows:
XTP position — Set this switch to the XTP position if the receiving device is an
•
Extron XTP CrossPoint matrix switcher. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
HDBT position — Set this switch to the HDBT position for HDBaseT-enabled
•
receivers. The TP output consists of HDMI with embedded audio plus RS-232 and
IR.
DTP position — Set this switch to the DTP position if the connected device is an
•
Extron DTP receiver. The TP output consists of HDMI with embedded audio, analog
audio, RS-232 and IR, and remote power.
TP output (see
figure 4
F
between these RJ-45 connectors and compatible Extron DTP receivers,
XTP matrix switchers, or HDBaseT-enabled devices (see
on page 19 to wire the connector).
The following table identifies the TP outputs by matrix size.
Matrix
Outputs
10x8
5B, 6B, 7, 8
8x4
3B, 4B
ATTENTION:
•
Do not connect this port to a computer data or telecommunications network.
•
Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
The video and embedded audio signal output on the TP output nB output is
NOTE:
duplicated on nA HDMI (for example, output 5A duplicates output 5B).
figure 5
and
on page 12) — Connect STP cables
Matrix
Outputs
8x6
3B, 4B, 5, 6
8x2
1B, 2B
DTP CrossPoint 4K Series Matrix Switchers • Installation
SIG
TP connectors
OUT
LINK
14