Table of Contents
Advertisement
Operation and Setup, cont'd
Unmuting an output
To unmute an output signal, do the following;
1.
2.
3.
N Output buttons with muted signals flash the relevant color; green for video, red
4.
I/O Presets
The SMX has a total of thirty-two global preset (using I/O buttons 1-16) and ten
plane preset (using Input buttons 1-10) addresses available.
N A global preset saves and recalls configurations for all planes.
Each global preset can be saved and recalled using the front panel input and output
buttons with presets 1 through 16 assigned to the input buttons, and presets 17
through 32 assigned to the output buttons. Likewise, plane presets are saved
to and recalled from input buttons 1 through 10. Any current tie configuration
can be saved to any one of the preset locations, in any order. Saving the current
configuration to an existing preset overwrites the existing preset in favor of the new
configuration.
PLANE
GLOBAL
GLOBAL
Figure 3-12 — Preset addresses
When a preset is recalled, it replaces the current (active) configuration which is
then lost unless already saved to a different preset location. The recalled preset
overwrites all of the current configuration ties, in favor of the recalled configuration
Read all the notes below.
N Presets cannot be viewed from the front panel unless recalled as the current
3-10
SMX System MultiMatrix Switchers • Operation and Setup
Press the Esc button to clear all pending changes.
Press and release the View button (lights red).
Press and hold the desired muted output button for 2 seconds, until the
button light ceases to flash and remains lit. The signal is now unmuted.
for audio, and amber for both. Unmuted signals are lit the relevant color.
Press and release the View button. All buttons extinguish.
A plane preset saves and recalls the configurations for a specific plane, without
it affecting the other plane connections.
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
17
18
19
20
21
22
configuration. Presets can be seen using the Windows based SMX Control
Program.
The current configuration and all other presets are stored in non-volatile
memory. When power is removed and restored, the current configuration
remains active and all presets are retained.
When a preset is recalled, it replaces the current configuration, which is lost
unless it is also stored as a preset. The recalled preset overwrites all of the
current configuration ties in favor of its own ties.
Ties for all I/O planes are stored and recalled: audio gain settings are not saved
with the preset and do not change when a preset is recalled.
When the plane preset mode is active, input buttons light for all saved presets.
7
8
9
10
7
8
9
10
11
12
13
INPUTS
7
8
9 10 11 12 13 14 15 16
7
8
9 10 11 12 13 14 15 16
OUTPUTS
23
24
25
26
27
28
29
14
15
16
30
31
32
Advertisement
Table of Contents
