Show Process Cpu Sort - Cisco Nexus 7000 Series Reference Manual

show process cpu sort

show process cpu sort
To display information about CPU processes sorted by CPU utilization, use the show process cpu sort
command.
Syntax Description 5sec
1min
5min
Defaults None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.2(2)
4.1(1)
Usage Guidelines The modules perform the polling and send messages to the supervisor module for Simple Network
Management Protocol (SNMP) caching. When attached to a module under no load, the CPU spikes
approximately every 10 seconds for a short period of time. The name of the process is statsclient.
The CPU spike can go up to 100 percent for a few milliseconds. The process is preemptive and it does
not block other high priority processes.
This command does not require a license.
Examples This example shows how to display information about CPU processes sorted by CPU utilization:
switch(config)# show process cpu sort
PID
-----
3622
Cisco Nexus 7000 Series NX-OS System Management Command Reference
592
show process cpu sort [5sec | 1min | 5min]
(Optional) Displays the sorted output based on the processes that use the
memory for five seconds.
(Optional) Displays the sorted output based on the processes that use the
memory for one minute.
(Optional) Displays the sorted output based on the processes that use the
memory for five minutes.
Modification
Added the 5sec, 1min, and 5min keywords.
This command was introduced.
Runtime(ms) Invoked
----------- --------
2335 6843
uSecs 1Sec Process
----- ------ -----------
341 50.0% pfstat
Show Commands
OL-25806-03