Ptp Priority1 - Cisco Nexus 7000 Series Reference Manual

ptp priority1

ptp priority1
To configure the priority1 value when advertising the Precision Time Protocol (PTP) clock, use the ptp
priority1 command. To remove the priority1 value, use the no form of this command.
Syntax Description priority-number
Defaults
255
Command Modes Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# ptp priority1 10
This example shows how to remove the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# no ptp priority1 10
Related Commands Command
feature ptp
ptp source
ptp domain
ptp priority2
show ptp brief
show ptp clock
Cisco Nexus 7000 Series NX-OS System Management Command Reference
336
ptp priority1 priority-number
no ptp priority1 priority-number
Priority number. The range is from 0 to 255.
Modification
This command was introduced.
Description
Enables or disables PTP on the device.
Configures the source IP address for all PTP packets.
Configures the domain number to use for this clock.
Configures the priority2 value to use when advertising this clock.
Displays the PTP status.
Displays the properties of the local clock.
P Commands
OL-25806-03