Lldp Tlv-Select - Cisco Nexus 7000 Series Reference Manual

lldp tlv-select

lldp tlv-select
To configure the type, length, and value (TLV) descriptions to send and receive in Link Layer Discovery
Protocol (LLDP) packets, use the lldp tlv-select command. To remove the TLV configuration, use the
no form of this command.
Syntax Description
dcbxp
management-address (Optional) Specifies the Management Address TLV.
port-description
port-vlan
system-capabilities
system-description
system-name
Defaults By default, all available TLVs are enabled.
Command Modes
Global configuration mode (config)
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(1)
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
236
lldp tlv-select [dcbxp | management-address | port-description | port-vlan | system-capabilities
| system-description | system-name]
no lldp tlv-select [dcbxp | management-address | port-description | port-vlan |
system-capabilities | system-description | system-name]
(Optional) Specifies the DCBXP TLV.
(Optional) Specifies the Port Description TLV.
(Optional) Specifies the Port VLAN ID TLV.
(Optional) Specifies the System Capabilities TLV.
(Optional) Specifies the System Description TLV.
(Optional) Specifies the System Name TLV.
Modification
This command was introduced.
L Commands
OL-25806-03