Ptp Source - Cisco Nexus 7000 Series Reference Manual

P Commands

ptp source

To configure the global source for all the Precision Time Protocol (PTP) packets, use the ptp source
command. To remove the global source for PTP packets, use the no form of this command.
Syntax Description ip_address
vrf
vrf-id
Defaults
None
Command Modes
Global configuration mode (source)
Supported User Roles network-admin
vdc-admin
Command History Release
6.1(1)
5.2(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to configure the global source for all PTP packets:
switch# configure terminal
switch(config)# ptp source 10.1.1.1
switch(config)#
This example shows how to remove the global source configuration for all PTP packets:
switch(config)# no ptp source 10.1.1.1
switch(config)#
Related Commands Command
feature ptp
ptp domain
OL-25806-03
ptp source ip_address [vrf vrf-id]
no ptp source ip_address [vrf vrf-id]
IPv4 address of the source.
Specifies the VRF to be used for hello messages.
Specifies the VRF ID.
Modification
vrf option is deprecated in Cisco NX-OS 6.1(1) release.
This command was introduced.
Description
Enables or disables PTP on the device.
Configures the domain number to use for this clock.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
ptp source
339