Filter Access-Group - Cisco Nexus 7000 Series Reference Manual

filter access-group

filter access-group
To apply an access group to an Encapsulated Remote Switched Port Analyzer (ERSPAN) source session,
use the filter access-group command. To remove an access group, use the no form of this command.
Syntax Description acl_filter
Defaults None
Command Modes config-monitor-erspan-src
Supported User Roles
network-admin
VDC-admin
Command History Release
5.1(1)
Usage Guidelines
Only the permit to deny actions are allowed for Encapsulated Remote Switched Port Analyzer
(ERSPAN) access control list (ACL) filters.
For information about ACL-related commands, see the Cisco Nexus 7000 Series NX-OS Security
Command Reference.
This command does not require a license.
Examples This example shows how to apply an access group to an ERSPAN session:
switch# configure terminal
switch(config)# monitor session 3 type erspan-source
switch(config-monitor-erspan-src)# filter vlan 3-5, 7
switch(config-monitor-erspan-src)# filter access-group ACL1
This example shows how to disassociate an access group to an ERSPAN session:
switch# configure terminal
switch(config)# monitor session 3 type erspan-source
switch(config-monitor-erspan-src)# filter vlan 3-5, 7
switch(config-monitor-erspan-src)# no filter access-group ACL1
Cisco Nexus 7000 Series NX-OS System Management Command Reference
186
filter access-group acl_filter
no filter access-group acl_filter
Access control list (ACL) name. An ACL associates the access list with the
SPAN session.
Modification
This command was introduced.
F Commands
OL-25806-03