Monitor Counter - Cisco Nexus 7000 Series Reference Manual

monitor counter

monitor counter
To configure a Simple Network Management Protocol (SNMP) monitor counter, use the monitor
counter command. To remove a monitor counter configuration, use the no form of this command.
Syntax Description invalid-crc
invalid-words
link-loss
protocol-error
rx-performance Configure the ingress (rx) performance counter.
signal-loss
state-change
sync-loss
tx-performance Configures the egress (tx) performance counter.
Defaults
None
Command Modes Port-monitor configuration (config-port-monitor)
Supported User Roles network-admin
vdc-admin
Command History Release
4.1(2)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure an SNMP counter:
switch(config) port-monitor name PM1
switch(config-port-monitor)# monitor counter signal-loss
switch(config-port-monitor)#
This example shows how to remove a counter configuration:
Cisco Nexus 7000 Series NX-OS System Management Command Reference
272
monitor counter {invalid-crc | invalid-words | link-loss | protocol-error | rx-performance |
signal-loss | state-change | sync-loss | tx-performance}
no monitor counter {invalid-crc | invalid-words | link-loss | protocol-error | rx-performance |
signal-loss | state-change | sync-loss | tx-performance}
Configures the invalid-crc counter.
Configures the invalid-words counter.
Configures the link-loss counter.
Configures the protocol-error counter.
Configures the signal-loss counter.
Configures the state-change counter.
Configures the sync-loss counter.
Modification
This command was introduced.
M Commands
OL-25806-03