Snmp Linkchange Trap Settings - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Parameter
The fields that can be configured in Trap Settings are described below:
Parameter
Trap Global State
SNMP Authentication Trap
Port Link Up
Port Link Down
Coldstart
Warmstart
Click the Apply button to accept the changes made.

SNMP Linkchange Trap Settings

This window is used to display and configure the SNMP link change trap settings.
To view the following window, click Management > SNMP > SNMP Linkchange Trap Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Trap Sending
Description
sending the SNMP trap packet.
Description
Select this option to enable or disable the sending of all or specific SNMP
notifications.
Tick this option to control the sending of SNMP authentication failure notifications.
An authenticationFailuretrap is generated when the device receives an SNMP
message that is not properly authenticated. The authentication method depends
on the version of SNMP being used. For SNMPv1 or SNMPv2c, authentication
failure occurs if packets are formed with an incorrect community string. For
SNMPv3, authentication failure occurs if packets are formed with an incorrect
SHA/MD5 authentication key.
Tick this option to control the sending of port link up notifications. A linkup trap is
generated when the device recognizes that one of the communication links has
come up.
Tick this option to control the sending of port link down notifications. A linkDown
trap is generated when the device recognizes a failure in one of the
communication links.
Tick this option to control the sending of SNMP coldStart notifications.
Tick this option to control the sending of SNMP warmStart notifications.
Figure 4-8 SNMP Linkchange Trap Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select this option to enable or disable the sending of the SNMP notification traps
33