D-Link DXS-3400 SERIES Web Ui Reference Manual page 442

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Click the Start button to initiate the Ping Test for each individual section.
The fields that can be configured in IPv6 Ping are described below:
Parameter
Target IPv6 Address
Domain Name
Ping Times
Timeout
Frequency
Source IPv6 Address
Click the Start button to initiate the Ping Test for each individual section.
After clicking the Please Select button, the following window will appear:
Select the radio button next to the entry to use that ACL in the configuration.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the OK button to accept the selection made.
After clicking the Start button in IPv4 Ping section, the following IPv4 Ping Result section will appear:
Click the Stop button to halt the Ping Test.
Click the Back button to return to the IPv4 Ping section.
Description
Enter an IPv6 address to be pinged.
Select and enter the domain name of the system to discover.
Enter the number of times desired to attempt to Ping the IPv6 address configured
in this window. Users may enter a number of times between 1 and 255. Tick the
Infinite check box to keep sending ICMP Echo packets to the specified IPv6
address until the program is stopped.
Select a timeout period between 1 and 99 seconds for this Ping message to reach
its destination. If the packet fails to find the IP address in this specified time, the
Ping packet will be dropped.
Enter the frequency time for the ping here. The range is from 0 to 86400.
Enter the source IPv6 address. If the current Switch has more than one IPv6
address, you can enter one of them to this field. When entered, this IPv6 address
will be used as the packets' source IP address sent to the remote host, or as
primary IP address.
Figure 13-22 Ping (Please Select) Window
Figure 13-23 Ping (Start) Window
432