Vlan Mapping - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Parameter
Unit
From Port ~ To Port
Trust Inner Priority
Miss Drop
Insert Dot1q Tag
VLAN Mapping Profile
Action
Click the Apply button to accept the changes made.

VLAN Mapping

This window is used to display and configure the VLAN mapping settings. If a profile is applied on an interface, the
Switch matches the incoming packets according to the rules of the profile. If the packets match a rule, the action of the
rule will be taken. The action may be adding or replacing the outer-VID. Optionally, specify the priority of the new
outer-TAG or specify the packets new inner-VID.
The match order depends on the rule's sequence number of the profile and stopped when first matched. If the
sequence number is not specified, it will be allocated automatically. The sequence number begins from 10 and the
increment is 10. Multiple different types of profiles could be configured onto one interface.
To view the following window, click L2 Features > VLAN Tunnel > VLAN Mapping, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Port
Original VID List
Description
Select the Switch's unit ID that will be used here.
Select the Switch's port range that will be used here.
Select to enable or disable the 802.1Q inner trust priority feature here. When the
trusting priority option, on an 802.1Q tunnel port, is enabled the priority of the
VLAN tag in the received packets will be copied to the service VLAN tag.
Select to enable or disable the miss drop feature here. If the VLAN mapping miss
drop option is enabled on the receiving port, when the original VLAN of the
received packets cannot match the VLAN mapping entries or rules on this port,
the received packets will be dropped.
Enter the 802.1Q VLAN ID that is inserted to the untagged packets which are
received on the 802.1Q tunnel port(s) here. The range is from 1 to 4094.
Enter the ID of the VLAN mapping profile here. A lower ID has a higher priority.
The ID range is from 1 to 1000.
Select Add to add a new entry based in the information entered.
Select Remove to remove an entry based in the information entered.
Figure 5-42 VLAN Mapping Settings Window
Description
Select the Switch's unit ID that will be used here.
Select the Switch's port range that will be used here.
Select the Switch's port that will be used for the search here.
Enter the original VLAN's ID list here. The range is from 1 to 4094.
131