L2Vlan Interface Description - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
VLAN Mode
Acceptable Frame
Ingress Checking
Native VLAN
VID
Action
Allowed VLAN Range
Clone
From Port ~ To Port
Click the Apply button to accept the changes made.
Click the Back button to discard the changes made and return to the previous page.

L2VLAN Interface Description

This window is used to display and configure the Layer 2 VLAN interface description.
To view the following window, click L2 Features > VLAN > L2VLAN Interface Description, as shown below:
Figure 5-28 VLAN Interface (Trunk Secondary) Window
Description
Select the VLAN mode option here. Options to choose from are Access, Hybrid,
Trunk, 802.1Q-Tunnel, Promiscuous, Host, Trunk Promiscuous, and Trunk
Secondary.
Select the acceptable frame behavior option here. Options to choose from are
Tagged Only, Untagged Only, and Admit All.
After selecting Trunk Secondary as the VLAN Mode the following parameter will
be available. Select to enable or disable the ingress checking function.
Tick this option to enable the native VLAN function. Also select if this VLAN
supports Untagged or Tagged frames.
After ticking the Native VLAN option the following parameter will be available.
Enter the VLAN ID used for this configuration here. This value must be between 1
and 4094.
Select the action that will be taken here. Options to choose from are All, Add,
Remove, Except, and Replace.
Enter the allowed VLAN range information here.
Select this option to enable the clone feature.
Select the range of ports that will be used in the clone feature here.
120