Snmp Trap Settings; Snmp User Table - D-Link DES-6500 - Switch User Manual

SNMP settings are configured using the menus located on the SNMP V3 folder of the web manager. Workstations on the network
that are allowed SNMP privileged access to the Switch can be restricted with the Management Station IP Address menu.

SNMP Trap Settings

The following window is used to enable or disable SNMP traps on the Switch. There are two types of traps located on the Switch,
SNMP traps and SNMP Authenticate traps which the user may enable or disable by using the corresponding pull-down menu.
After changes are made, click the Apply button to save it to the Switch's memory.

SNMP User Table

The SNMP User Table displays all of the SNMP User's currently configured on the Switch.
In the SNMP Manager folder, click on the SNMP User Table link. This will open the SNMP User Table, as shown below.
To delete an existing SNMP User Table entry, click the
To display the detailed entry for a given user, click on the hyperlinked User Name. This will open the SNMP User Table Display
page, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 8 - 1. SNMP Trap Settings window
Figure 8 - 2. SNMP User Table
Figure 8 - 3. SNMP User Table Display
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
below the Delete heading corresponding to the entry to delete.
205