D-Link DXS-3400 SERIES Web Ui Reference Manual page 253

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
None
Specify
Average Rate
Normal Burst Size
Maximum Burst Size
Conform Action
Exceed Action
Figure 7-18 Policy Map (Policer) Window
Description
Select this option to specify that no policer settings will be configured for this
entry.
Select this option to specify that the following policer settings will be applied to
this entry.
Enter the average rate value here. The range is from 0 to 10000000 Kbps.
Enter the normal burst size value here. The range is from 0 to 16384 Kbps.
Enter the maximum burst size value here. The range is from 0 to 16384 Kbps.
Select the conform action that will be taken here. This action will be taken on
green color packets. Option to choose from are:
• Drop - Specifies that the conform action is to drop the packet.
• Set-DSCP-Transmit - Specifies that the conform action is to modify the
DSCP value and then to transmit the packet with the new DSCP value. Enter
the new DSCP value in the space provided.
• Set-1P-Transmit - Specifies that the conform action is to modify the 802.1p
value and then to transmit the packet with the new 802.1p value. Enter the
new 802.1p value in the space provided.
• Transmit - Specifies that the conform action is to transmit the packet
unmodified.
• Set-DSCP-1P - Specifies that the conform action is to modify the DSCP and
802.1p values and then to transmit the packet with the new DSCP and
802.1p values. Enter the new DSCP and 802.1p values in the spaces
provided.
Select the exceed action that will be taken here. This action will be taken on
yellow color packets that exceed the rate limit. Option to choose from are:
• Drop - Specifies that the exceed action is to drop the packet.
• Set-DSCP-Transmit - Specifies that the exceed action is to modify the
DSCP value and then to transmit the packet with the new DSCP value. Enter
the new DSCP value in the space provided.
• Set-1P-Transmit - Specifies that the exceed action is to modify the 802.1p
value and then to transmit the packet with the new 802.1p value. Enter the
new 802.1p value in the space provided.
243