D-Link DXS-3400 SERIES Web Ui Reference Manual page 208

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Parameter
IPv6 Address
Click the Apply button to accept the changes made.
The fields that can be configured for NS Interval Settings are described below:
Parameter
NS Interval
Click the Apply button to accept the changes made.
The fields that can be configured for ND Settings are described below:
Parameter
Hop Limit
Reachable Time
Managed Config Flag
Other Config Flag
RA Min Interval
RA Max Interval
RA Lifetime
RA Suppress
Click the Apply button to accept the changes made.
After selecting the Interface IPv6 Address tab option, at the top of the page, the following page will be available.
Click the Delete button to delete the specified entry.
After selecting the Neighbor Discover tab option, at the top of the page, the following page will be available.
Description
Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to
configure an IPv6 address on the interface using the EUI-64 interface ID. Select
the Link Local option to configure a link-local address for the IPv6 interface.
Description
Enter the Neighbor Solicitation (NS) interval value here. The range is from 0 to
3600000 milliseconds, in multiples of 1000. If the specified time is 0, the router will
use 1 second on the interface and advertise 0 (unspecified) in the RA message.
Description
Enter the hop limit value here. The range is from 0 to 255. The IPv6 packet
originated at the system will also use this value as the initial hop limit.
Enter the reachable time here. The range is from 0 to 3600000 milliseconds. If the
specified time is 0, the router will use 1200 seconds on the interface and advertise
1200 (unspecified) in the RA message. The reachable time is used by the IPv6
node in determining the reachability of the neighbor nodes.
Turn the managed config flag option On or Off here. When the neighbor host
receives the RA which has flag turned on, the host should use a stateful
configuration protocol to obtain IPv6 addresses.
Turn the other config flag option On or Off here. By setting the other configuration
flag on, the router instructs the connected hosts to use a stateful configuration
protocol to obtain auto-configuration information other than the IPv6 address.
Enter the minimum RA interval time value here. The range is from 3 to 1350
seconds. This value must be smaller than 0.75 times the maximum value.
Enter the maximum RA interval time value here. The range is from 4 to 1800
seconds.
Enter the RA lifetime value here. The range is from 0 to 9000 seconds. The
lifetime value in RA instructs the received host the lifetime value for taking the
router as the default router.
Select to enable or disable the RA suppress feature here.
Figure 6-12 IPv6 Interface (Detail, Interface IPv6 Address) Window
198