D-Link DXS-3400 SERIES Web Ui Reference Manual page 144

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Parameter
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Add Rule button next to an IP type profile, the following page will appear.
The fields that can be configured are described below:
Parameter
Rule ID
Src-IP Address (IP/Mask)
Dst-IP Address (IP/Mask)
DSCP
Source Port
Destination Port
IP Protocol
Action
New Outer VID
802.1P Priority
New Inner VID
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
Description
was selected as the action.
Figure 5-45 VLAN Mapping Profile (IP, Add Rule) Window
Description
Enter the VLAN mapping rule's ID here. If not specified, the rule ID begins from
10 and is incremented by 10 for every new rule. The range is from 1 to 10000
Enter the source IPv4 address and subnet mask here.
Enter the destination IPv4 address and subnet mask here.
Enter the DSCP value here. The range is from 0 to 63.
Enter the source TCP/UDP port's number here. The range is from 1 to 65535.
Enter the destination TCP/UDP port's number here. The range is from 1 to 65535.
Enter the Layer 3 IP protocol value here. The range is from 0 to 255.
Select the action that will be taken here. Options to choose from are Dot1q-
Tunnel and Translate.
• Dot1q-Tunnel - Specifies that the outer-VID will be added for matched
packets.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
Enter the new outer VLAN's ID here. The range is from 1 to 4094.
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
After selecting Dot1q-Tunnel as the action, enter the new inner VLAN's ID here.
The range is from 1 to 4094. This option is only available when Dot1q-Tunnel
was selected as the action.
134