Telnet/Web - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide

Telnet/Web

This window is used to display and configure Telnet and Web settings on the Switch.
To view the following window, click Management > Telnet/Web, as shown below:
The fields that can be configured in Telnet Settings are described below:
Parameter
Telnet State
Port
Click the Apply button to accept the changes made.
The fields that can be configured in Source Interface are described below:
Parameter
Source Interface State
Type
VID
Click the Apply button to accept the changes made.
The fields that can be configured in Web Settings are described below:
Parameter
Web State
Port
Click the Apply button to accept the changes made.
Figure 4-23 Telnet/Web Window
Description
Select this option to enable or disable the configuration through Telnet.
Enter the TCP port number used for Telnet management of the Switch. The "well-
known" TCP port for the Telnet protocol is 23.
Description
Select to enable or disable the source interface's state here.
Select the type of source interface that will be used here. Options to choose from
are Loopback, Mgmt, and VLAN.
Enter the interface's ID here. For loopback interfaces the range is from 1 to 8. For
the management (Mgmt) interface this value can only be 0. For VLAN interfaces
the range is from 1 to 4094.
Description
Select this option to enable or disable the configuration through the web.
Enter the TCP port number used for Telnet management of the Switch. The "well-
known" TCP port for the Telnet protocol is 80.
44