D-Link DXS-3400 SERIES Web Ui Reference Manual page 395

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured in Ethernet OAM Settings are described below:
Parameter
Unit
From Port ~ To Port
State
Mode
Received Remote
Loopback
Remote Loopback
Figure 10-22 Ethernet OAM Settings Window
Description
Select the Switch's unit ID that will be used here.
Select the Switch's port range that will be used here.
Select to enable or disable the Ethernet OAM feature on the specified port(s)
here. After enabling this function on the interface, the interface will start OAM
discovery. If the OAM mode of this interface is active, it initiates the discovery.
Otherwise, it reacts to the discovery received from the peer.
Select the Ethernet OAM mode here. Options to choose from are Active and
Passive. The following two actions are allowed by ports in the active mode, but
disallowed by ports in the passive mode. (1) Initiate OAM discovery. (2) Start or
stop remote loopback.
Select to configure the behavior of the received remote loopback requirement
from the peer on the specified port(s) here. Options to choose from are Ignore
and Process.
• Ignore - Specifies not to react to remote loopback requirements from a peer.
• Process - Specifies to react to remote loopback requirements from a peer.
The feature is used to configure the client to process or to ignore the received
Ethernet OAM remote loopback feature. In the remote loopback mode, all user
traffic will not be processed. Ignoring the received remote loopback feature will
prevent the port from entering the remote loopback mode.
Select the remote loopback action here. Options to choose from are Start and
Stop.
• Start - Specifies to request the peer to change to the remote loopback mode.
385