Ethernet Oam Configuration Settings - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
Parameter
Click the Apply button to accept the changes made.
The fields that can be configured in Ethernet OAM Table are described below:
Parameter
Unit
From Port ~ To Port
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.

Ethernet OAM Configuration Settings

This window is used to display and configure the Ethernet OAM feature's configuration settings.
To view the following window, click OAM > Ethernet OAM > Ethernet OAM Configuration Settings, as shown below:
Description
• Stop - Specifies to request the peer to change to the normal operation mode.
If the remote peer is configured to ignore the remote loopback request, then the
remote peer will not enter or exit the remote loopback mode upon receiving the
request. To start the remote peer to enter the remote loopback mode,
administrators must ensure that the local client is in the active mode and the OAM
connection is established. If the local client is already in the remote loopback
mode, then this feature cannot be applied.
Description
Select the Switch's unit ID that will be used here.
Select the Switch's port range that will be used here.
386