Automatically Configuring Settings Using Ntp - Konica Minolta bizhub C754 User Manual
Hide thumbs
Also See for bizhub C754:
- User manual (427 pages) ,
- Quick start manual (130 pages) ,
- Shortcut manual (33 pages)
Table of Contents
Advertisement
4
Automatically configuring settings using NTP
Using the NTP (Network Time Protocol) server allows you to automatically adjust the date and time of this
machine.
Register the NTP server used. To periodically adjust the date and time by connecting to the NTP server, spec-
ify an interval for adjusting the date and time.
0
To adjust the date and time using the NTP server, you must connect this machine to the network.
1
In the administrator mode, select [Maintenance] - [Date/Time Setting] - [Manual Setting], then configure
the [Time Zone] setting.
% For details on how to configure [Time Zone] setting, refer to page 4-5.
2
In the administrator mode, select [Maintenance] - [Date/Time Setting] - [Time Adjustment Setting], then
configure the following settings.
Settings
[Time Adjustment Setting]
[Auto IPv6 Retrieval]
[NTP Server Address]
[Port No.]
[Auto Time Adjustment]
[Polling Interval]
3
Click [Adjust].
Connect to the NTP server, and adjust the date and time of this machine.
4-6
Setting the date and time for the machine
Description
To automatically adjust the date and time of this machine via the NTP serv-
er, select [OFF].
[OFF] is specified by default.
Select [ON] to automatically specify the NTP server address.
In the IPv6 environment, the NTP server address can be automatically
specified by DHCPv6.
[ON] is specified by default.
Enter the NTP server address.
Use one of the following formats.
•
Example of host name entry: "host.example.com"
•
Example of IP address (IPv4) entry: "192.168.1.1"
•
Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
If necessary, change the NTP server port number.
Normally, you can use the original port number.
[123] is specified by default.
To periodically adjust the date and time by connecting to the NTP server,
select [ON]. Also, specify an interval for adjusting the date and time at [Poll-
ing Interval].
[OFF] is specified by default.
If you select [ON] for [Auto Time Adjustment], specify an interval to auto-
matically adjust the date and time of this machine (unit: hours).
4.3
bizhub C754/C654
Advertisement
Table of Contents
