Upgrading The Secondary Ip Messaging Server - 3Com VCX V7000 Maintenance Manual

270 A C: U
PPENDIX PGRADING
Upgrading the
Secondary IP
Messaging Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
VCX S S
ERVER OFTWARE
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.0.x IP
Telephony services.
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
6 Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Follow the steps in this section to upgrade the secondary IP Messaging
server.
1 To start the upgrade process, enter these commands on the secondary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Obtain a license key for the server. See
3 Install the license key. See
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc
F V6.0 V7.0
ROM TO
Installing a License Key
Obtaining a License Key
File.
File.