Monitoring Ups Status - 3Com VCX V7000 Maintenance Manual

136 C 8: M
HAPTER ANAGING
Monitoring UPS
Status
U P S
NINTERRUPTIBLE OWER
The optional argument
run in automatic mode. In this mode, command execution does not
provide any interactive prompts or queries.
Note that you can enter the
argument to display information on command usage.
--help
This section describes how to check the status of a UPS
You can use the
vcx-ups-status
UPS in your local VCX system, or the status of a UPS in a remote VCX
system. You can enter the command on the master server or any slave
server. The
vcx-ups-status
vcx-ups-status (ups0 | ups1)[master-ip] [--parameter]
You must identify the UPS you want to monitor. For a single UPS system,
enter . For a dual UPS system, enter either
ups0
on the UPS you want to monitor.
The parameter
master-ip
address of a remote VCX UPS master server.
In addition to the required parameter
of the parameters shown in
Table 10 vcx-ups-status Command Parameters
Parameter
--upsstatus
--upsload
--upsmfr
--batterycharge
--upsserial
--upsmodel
--isconfig
UPPLIES
specifies that the command should
--fullauto
vcx-ups-setup
command to check the status of any
command uses the following syntax:
is optional. Use this parameter to specify the IP
ups0
Table 10.
Description
Indicates the status of the UPS, for example online or
offline.
Indicates the load, expressed in watts, placed on the UPS by
the attached VCX servers.
Displays the name of the UPS manufacturer. In this case, the
value is always APC.
Indicates, as a percentage, the current battery charge.
Displays the manufacturer's serial number of the UPS.
Displays the manufacturer's model name of the UPS.
Indicates whether or not (Y or N) the UPS has been
configured.
command with the optional
or , depending
ups0 ups1
or , you must enter one
ups1