3Com VCX V7000 Maintenance Manual page 224

224 A B: U
PPENDIX PGRADING
VCX S S
ERVER OFTWARE
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary VCX server and the secondary VCX
server.
b The
Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE
Press Enter to accept the default.
c The
Enter the MASTER DEFINITION SITE IP Address [IP
prompt appears.
address]
Enter the IP address of the Master Definition site or press Enter if the
displayed address is correct. This is typically the IP address of eth0 on
the primary VCX server.
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0]
appears.
Enter the IP address of the Master Site. This is typically the IP address
of eth0 on the secondary VCX server.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter to continue. The script executes.
y
During script execution, messages appear describing the replication
setup. Messages also appear stating that firewall setup should allow
communication between the primary VCX server and the secondary
VCX server. These messages are a reminder—firewall setup was
performed during VCX software installation.
f The
Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]:
Enter to continue. The script executes.
y
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
g You can check the replication by entering the following command:
./checkReplication
3 When the replication is complete and status is reported as NORMAL,
enter the following command to exit the cworks account and return to
the root account:
exit
F V7.1. V7.1.
ROM X TO Y
[1]: prompt appears.
prompt appears.
prompt