3Com VCX V7000 Maintenance Manual page 104

104 C 7: R
HAPTER ECONFIGURING A
Sample VCX Reconfiguration Script
---------------------------------------------------------------------------
--------------- Welcome to the VCX Reconfiguration Utility ----------------
---------------------------------------------------------------------------
This utility allows a previously configured VCX system to be reconfigured -
for example, to change its IP address or the IP addresses of other VCX
servers with which it communicates.
To accomplish this, it is necessary to carry out several steps including
stopping VCX services. If certain parameters are changed, it may also be
necessary to discontinue any replication which may be occurring with other
servers. Therefore, this utility should only be run on a system which is
not in active use.
Following reconfiguration, you must follow the VCX documentation to bring
all servers back online and to re-establish replication if it was dropped.
The correct procedures must be followed for this process to succeed.
Do you wish to reconfigure the system at this time? [no] : yes
Starting reconfiguration.
---------------------- Preparing For Reconfiguration ----------------------
VCX services are currently running - stopping them now.
Stopping VCX Services:
Stopping vcx/devdnldsvr:
Stopping vcx/callp:
Stopping vcx/tomcat:
Stopping vcx/ums:
Stopping vcx/bssxml:
Stopping vcx/acctxml:
Stopping vcx/vcxglobaldir:
Stopping vcx/vcxdata:
Stopping vcx/upsmon:
Stopped VCX Services: 9 stopped.
Do you want to change this system's networking configuration?
if you want to modify the system's IP addresses, default gateways, or
hostname. If you say 'yes' here, replication will be dropped if it is in
use.
Note: If you are *only* changing the system's NTP, DNS, or timezone
configuration, you can use 'vcx-config-network' instead of
'vcx-reconfigure'.
VCX S
ERVER
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
Answer 'yes'