Upgrading The Primary Ip Messaging Server - 3Com VCX V7000 Maintenance Manual

Upgrading the
Primary IP Messaging
Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
6 Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Follow the steps in this section to upgrade the primary IP Messaging
server.
1 To start the upgrade process, enter these commands on the primary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Obtain a license key for the server. See
3 Install the license key. See
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc
5 Specify whether this IP Messaging system will support IP Messaging
clients. The upgrade script displays the following prompt:
Will this system support IPMSG client systems? [N]:
Upgrading a Single-Site System With Four Servers
Obtaining a License Key
Installing a License Key
267
File.
File.