3Com VCX V7000 Maintenance Manual page 278

278 A C: U
PPENDIX PGRADING
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
VCX S S
ERVER OFTWARE
15 Enter the following command to exit the cworks account and return to
the root account:
exit
16 Obtain a copy of the
and place it in the
and Directory server. The variable
(for example,
vcx-dataserver-7.0.3c.tar)
6.0. The letter
c
17 Enter these commands:
cd /opt/installtemp
tar xvf vcx-dataserver-7.0.xc.tar
cd upgrade-7.0.x
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
18 Obtain a license key for the server. See
19 Install the license key. See
20 Change to the new software version by entering this command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. When the
reboot process has been completed, the system starts VCX 7.0.xc
Authentication and Directory service.
21 After the system has completed the restart process, verify that the
upgrade has occurred by entering the following command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output:
22 Enter the following commands to stop the Authentication and Directory
server on Region 2:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
F V6.0 V7.0
ROM TO
vcx-dataserver-7.0.xc.tar
/opt/installtemp
indicates the version of VCX software
x
is always appended to the version number.
Installing a License Key
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
software upgrade file
directory on the Authentication
that will replace version
Obtaining a License Key
File.
File.