Upgrading The Secondary Ip Telephony Server - 3Com VCX V7000 Maintenance Manual

Upgrading the
Secondary IP
Telephony Server
1 To start the upgrade process, enter these commands on the secondary IP
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
2 Switch to the new software version by entering the following command:
3 After the system has completed the restart process, verify that the
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.yc
Follow the steps in this section to upgrade the secondary IP Telephony
server.
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.yc.tar
cd upgrade-7.1.yc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.1.y IP
Telephony services.
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Upgrading a Single-Site System With Four Servers 229