Upgrading The Primary Ip Telephony Server - 3Com VCX V7000 Maintenance Manual

Upgrading the
Primary IP Telephony
Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
7 Obtain a copy of the
place it in the
/opt/installtemp
server and on the secondary IP Messaging server.
Next, execute the following steps in the order listed:
Upgrade the primary IP Telephony server. See
■
Telephony Server.
Upgrade the primary IP Messaging server. See
■
IP Messaging Server.
Upgrade the secondary IP Telephony server. See
■
Secondary IP Telephony
Upgrade the primary IP Messaging server. See
■
Secondary IP Messaging
Set up database replication on the primary IP Telephony server. See
■
Up Database Replication.
Follow the steps in this section to upgrade the primary IP Telephony
server.
1 To start the upgrade process, enter these commands on the primary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.yc.tar
cd upgrade-7.1.yc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.1.y IP
Telephony services.
Upgrading a Single-Site System With Four Servers
vcx-ipmsg-7.1.yc.tar
directory on the primary IP Messaging
Server.
Server.
software upgrade file and
Upgrading the Primary IP
Upgrading the Primary
Upgrading the
Upgrading the
227
Set