Set Up Database Replication - 3Com VCX V7000 Maintenance Manual

4 After completing the UPS Monitoring prompts, the server reboots. When
5 After the system has completed the restart process, verify that the
Set Up Database
Replication
1 Stop the Tomcat process, first on the primary IP Telephony server and
2 Set up replication on the primary IP Telephony server by entering these
If you do not have a UPS installed and enter
remaining UPS configuration prompts are not displayed.
If you do have a UPS installed and enter
Monitoring for information on the subsequent UPS configuration
prompts.
the reboot process has been completed, the system starts VCX 7.1.x
services.
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
Follow the steps in this section to set up database replication.
then on the secondary IP Telephony server by entering these commands
(log in as root):
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id
appears.
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary IP Telephony server and the
secondary IP Telephony server.
Upgrading a Single-Site System With Four Servers
and see
y
(or press Enter); the
n
Configuring UPS
187
prompt