Upgrading The Primary Vcx Server - 3Com VCX V7000 Maintenance Manual

260 A C: U
PPENDIX PGRADING
Upgrading the
Primary VCX Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
VCX S S
ERVER OFTWARE
VCX software (for example,
version 6.0. The letter
Next, execute the following steps in the order listed:
Upgrade the primary VCX server. See
■
Server.
Upgrade the secondary VCX server. See
■
Server.
Set up database replication on the primary VCX server. See
■
Database Replication.
Follow the steps in this section to upgrade the primary VCX server.
1 To start the upgrade process, enter these commands on the primary VCX
server:
cd /opt/installtemp
tar xvf vcx-all-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Obtain a license key for the server. See
3 Install the license key. See
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.0.x
services.
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
F V6.0 V7.0
ROM TO
vcx-all-7.0.3c.tar)
is always appended to the version number.
c
Installing a License Key
that will replace
Upgrading the Primary VCX
Upgrading the Secondary VCX
Obtaining a License Key
File.
Set Up
File.