3Com VCX V7000 Maintenance Manual page 197

------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------
8 Change to the new software version by entering this command:
vcx-switchversion 7.1.xc
The system displays several status messages and provides prompts that
allow you enable UPS Monitoring.
9 The UPS Monitoring prompt appears:
An Uninterruptible Power Supply (UPS) can be used with VCX
systems to avoid disruption due to a power outage.
provides a UPS monitoring service which tracks the UPS's
status and performs a safe shutdown when the its battery is
depleted during a long power outage.
you must have a compatible UPS installed and configured in
accordance with the VCX documentation.
Enable UPS monitoring? [N]
If you do not have a UPS installed and enter
remaining UPS configuration prompts are not displayed.
If you do have a UPS installed and enter
Monitoring
prompts.
10 After completing the UPS Monitoring prompts, the server reboots. When
the reboot process has been completed, the system starts VCX 7.1.x
services.
After the system has completed the restart process, verify that the
upgrade has occurred by entering the following command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before presiding.
Example Output:
11 Enter the following commands to stop the Authentication and Directory
server on Region 2:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Upgrading a Multi-Site VCX System with Branch Offices
for information on the subsequent UPS configuration
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
To use this feature,
(or press Enter); the
n
and see Configuring UPS
y
197
VCX
: