3Com VCX V7000 Maintenance Manual page 288

288 A C: U
PPENDIX PGRADING
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
VCX S S
ERVER OFTWARE
4 To start the upgrade process, enter the following commands:
cd /opt/installtemp
tar xvf vcx-softswitch-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
5 Obtain a license key for the server. See
6 Install the license key. See
7 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.0.x
services.
8 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
9 Repeat steps 2 through 8 for all the other branch office servers in
Region 2.
10 After upgrading all the branches, restart the Tomcat process on the Call
servers in Region 2 by logging in to each server as root and executing the
following commands:
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat start
Be sure to run the admincfg script on each VCX server in the multi-site
system that runs the Call Processing service (IP Telephony and Messaging
F V6.0 V7.0
ROM TO
Installing a License Key
Obtaining a License Key
File.
File.