3Com VCX V7000 Maintenance Manual page 185

2 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.xc
The system displays several status messages and provides prompts that
allow you enable Adhoc Conferencing and UPS Monitoring.
3 The Adhoc Conferencing prompt appears:
In order to support "ad-hoc" conferences with more than 3
participants, the Adhoc Conference Service is used.
service should be enabled on this server, unless another
server dedicated to Adhoc Conferencing will be used instead.
If available, a separate server typically provides greater
capacity and may be shared among sites.
Use the Adhoc service on this server? (Y/N) [Y]
If you want this server to act as a multi-caller (up to 6 callers)
conferencing server, enter
4 The UPS Monitoring prompt appears:
An Uninterruptible Power Supply (UPS) can be used with VCX
systems to avoid disruption due to a power outage.
provides a UPS monitoring service which tracks the UPS's
status and performs a safe shutdown when the its battery is
depleted during a long power outage.
you must have a compatible UPS installed and configured in
accordance with the VCX documentation.
Enable UPS monitoring? [N]
If you do not have a UPS installed and enter
remaining UPS configuration prompts are not displayed.
If you do have a UPS installed and enter
Monitoring for information on the subsequent UPS configuration
prompts.
5 After completing the Adhoc Conferencing and UPS Monitoring prompts,
the server reboots. When the reboot process has been completed, the
system starts VCX 7.1.x services.
6 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
Upgrading a Single-Site System With Four Servers
. If not, enter .
y n
and see
y
This
VCX
To use this feature,
(or press Enter); the
n
Configuring UPS
185
:
: