Upgrading The Regional Call Records Server - 3Com VCX V7000 Maintenance Manual

246 A B: U
PPENDIX PGRADING
Upgrading the
Regional Call Records
Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
VCX S S
ERVER OFTWARE
4 Upgrade the secondary Call server by following the procedure described
in step 3.
This section describes how to upgrade regional the Call Records server. In
a multi-site VCX system, a single Call server typically supports all regional
offices. You need to perform the steps in this section on a console
attached to the regional Call server.
To upgrade the Call Records server:
1 Log in to the Call Records server as root.
2 Obtain a copy of the
place it in the
/opt/installtemp
3 Enter these commands:
cd /opt/installtemp
tar xvf vcx-bss-7.1.yc.tar
cd upgrade-7.1.yc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
4 Change to the new software version by entering this command:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. When the
reboot process has been completed, the system starts VCX 7.1.yc
services.
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering the following command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output:
F V7.1. V7.1.
ROM X TO Y
vcx-bss-7.1.yc.tar
directory on the Call Records server.
/opt/3com/VCX -> /opt/3com/VCX.7.1.yc
software upgrade file and