Upgrading The Secondary Ip Telephony Server - 3Com VCX V7000 Maintenance Manual

7 Stop IP Messaging. When the primary IP Messaging reboots, IP
8 If the returned status is
Upgrading the
Secondary IP
Telephony Server
1 To start the upgrade process, enter these commands on the secondary IP
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
2 Obtain a license key for the server. See
3 Install the license key. See
4 Switch to the new software version by entering the following command:
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
Messaging restarts and must be stopped before you can upgrade the
secondary IP Messaging server. However, you should ensure IP Messaging
is fully active before stopping it. To check IP Messaging status, enter the
following commands:
su - app
cd /opt/3com/VCX/UMS/vcx-scripts/init.d
./vcxums status
the following commands:
exit
cd /opt/3com/VCX/scripts/rc3.d
./S60ums stop
Follow the steps in this section to upgrade the secondary IP Telephony
server.
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
vcx-switchversion 7.0.xc
Upgrading a Single-Site System With Four Servers
, stop IP Messaging by entering
...running...
Obtaining a License Key
Installing a License Key
269
File.
File.