Managing The Accounting Service And The Authentication And Directory Service - 3Com VCX V7000 Maintenance Manual

56 C 3: M
HAPTER ANAGING
Managing the
Accounting Service
and the
Authentication and
Directory Service
VCX S
ERVERS
Using EMS
To restart the Call Processor service from EMS:
1 From the Explorer tab, right-click the 3Com Call Processor service.
2 From the pop-up menu, select Maintenance, then select Hard Restart
to shutdown and restart the Call Processor service.
This section describes maintenance tasks for the following VCX services
(sometimes referred to as back-end servers):
Accounting service
■
Authentication and Directory service
■
The location of each service depends on your VCX configuration.
The Accounting service always runs on the server hosting the IP
■
Telephony server.
The Authentication and Directory service can run on either the IP
■
Telephony server or, in some multi-site configurations, on the
Authentication and Directory server.
To determine where (the IP address) a service is running, enter the
following command (logged in as root) on the server hosting the primary
call processor:
vcx-config-services --show
This command returns a multi-page display that shows your VCX system
configuration, including lines similar to the following:
---------Displaying Accounting Service ---------
Local IP Address : 10.230.63.6
For information on configuring Accounting Service groups, see
Chapter 2.
For information on Authentication and Directory service database
maintenance, see Chapter 5.