Ramp Cover Replacement
Ramp Cover Replacement
Removal Instructions
1. Use a short stub #3 screwdriver to remove the fastener located on the underside front of
the ramp platform. Lift the front of the ramp cover
retaining clips. Retain fastener hardware for installation.
Installation Instructions
1. Reinstall ramp cover
clips and then pressing down (and/or using the palm of your hand to lightly strike the top
of the ramp) on the top front of the ramp to snap into the front bracket clip. Verify that the
ramp clips are correctly engaged by grabbing the ramp sides and gently attempting to
move and lift the ramp off the platform.
2. Secure ramp
Experience Series 800 Line EFX
by inserting the rear tabs into the rear ramp platform mounting
by reinstalling the #3 Phillips screw fastener and fully tighten.
5 Replacement Procedures
Covers and Panels Replacement
and slide forward to remove from
55