Table of Contents
Advertisement
Procedure 7.15 - Replacing a Ramp Assembly
Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm, when the
rear covers are removed.
1.
Remove the access panel, top, right and left rear covers per Procedure 7.1
2.
Remove both stairarms per procedure 7.14.
3.
Remove the two bolts that fasten the lower rear portion of the ramp to the frame. See
Diagram 7.12.
Diagram 7.12 - Lower Ramp Mounting
4.
Remove the two bolts that fasten the upper end of the ramp to the lift motor yoke. See
Diagram 7.13.
5.
Carefully lift the ramp and slide it off of the yoke.
6.
Slide the replacement ramp onto the yoke and hand start the two lower ramp mounting bolts
removed in step 5. Fasten the upper end of the ramp to the yoke with the hardware removed
in step 6. Install and torque the two lower ramp bolts to 480 inch pounds (40 foot pounds).
C534i Elliptical Fitness Crosstrainer
Lower Ramp
Mounting Bolt
Page 54
Advertisement
Table of Contents
Troubleshooting
