Procedure 7.18 - Replacing A Ramp Assembly - Precor EFX5.31 Instruction Manual

Procedure 7.18 - Replacing a Ramp Assembly

Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
Set the on/off switch in the "on" position. Press the QUICK START key, while striding on the
1.
unit raise the incline to its maximum position.
2. Set the on/off switch in the "off" position, then unplug the power cord from the wall outlet.
3. Remove the access panel, top, right and left rear covers per Procedure 7.1
4. Remove both stairarms per procedure 7.17.
5. Remove the two bolts that fasten the lower rear portion of the ramp to the frame. See
Diagram 7.14.
Diagram 7.14 - Lower Ramp Mounting
6. Remove the two bolts that fasten the upper end of the ramp to the lift motor yoke. See
Diagram 7.15.
7. Carefully lift the ramp and slide it off of the lift motor yoke.
8. Slide the replacement ramp onto the lift motor yoke and hand start the two lower ramp
mounting bolts removed in step 5. Fasten the upper end of the ramp to the lift motor yoke
with the hardware removed in step 6. Torque the two lower ramp bolts to 480 inch pounds
(40 foot pounds).
Lower Ramp
Mounting Bolt