Procedure 7.18 - Replacing A Ramp Assembly - Precor C556 Service Manual

Elliptical fitness crosstrainer
Hide thumbs Also See for C556:
Table of Contents

Advertisement

Procedure 7.18 - Replacing a Ramp Assembly

Procedure
1.
Set the on/off switch in the "off" position, then unplug the power cord from the wall outlet.
2.
Remove the three bolts that fasten each pivot arm connector to the stairarm. See Diagram
7.9.
3.
Remove the rear cover and rotate both stairarms to the rear of the unit.
4.
Remove the four screws that fasten the ramp end cap to the ramp assembly See Diagram
7.13. Slide the ramp end cap out of the ramp assembly and rotate the ramp assembly
toward the rear of the unit.
5.
Remove six rear ramp mounting bolts (3 each side).
Diagram 7.12 - Rear Ramp Mounting
Mounting Bolt
6.
Remove the two mounting bolts from the front bottom of the ramp assembly.
C556 Elliptical Fitness Crosstrainer
Page 60

Advertisement

Table of Contents
loading

Table of Contents