Procedure 7.18 - Replacing A Ramp Assembly - Precor EFX 5.17i Service Manual

Procedure 7.18 - Replacing a Ramp Assembly

Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
1. Set the on/off switch in the "off" position, then unplug the power cord from the wall outlet.
2. Remove the right and left rear covers per Procedure 7.1 and pivot both stairarms to the rear
of the unit.
Diagram 7.18 - Lower Ramp Mounting
3. Set the on/off switch in the "on" position, then plug the power cord into the wall outlet.
4. Lower the ramp to incline level 1 and set the on/off switch in the "off" position. Remove the
front cover per Procedure 7.1.
5. Remove the two retaining clips from the lift pins. While supporting the ramp, remove the two
lift pins and carefully lower the ramp assembly until it is resting on the rear portion of the
front cover. (See Diagram 5.5).
6. Remove the two bolts that fasten the lower rear portion of the ramp to the frame. See
Diagram 7.20.
7. Carefully lift the ramp out of the EFX.
8. Set the replacement ramp in its mounting position.
5.17i Ellipitical Fitness Crosstrainer
Lower
Ramp
Mounting
Page 68