Generator and Eddy Brake Assembly Replacement
About
This procedure provides instruction to remove and install the Generator and Eddy Brake
assembly.
Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the Drive Access cover, see
2. Remove the left and right Drive Disk covers, see
page 57.
3. Remove the one #2 Phillips screw fastener and
connect the Generator input cable (J1) and Eddy/Brake load cable (J7) from the LPCA
board. Retain fastener hardware for installation.
1
Lower PCA board
Experience Series 800 Line EFX
Generator and Eddy Brake Assembly Replacement
"Drive Access Cover Replacement" on
"Drive Disk Covers Replacement" on
1
LPCA
/Battery module cover. Dis-
5 Replacement Procedures
page 56.
77