Battery Replacement
About
This procedure provides instruction to determine the condition of the battery to remove and
install the Battery.
Determining the battery condition
Use the service software Hardware Validation BATTERY TEST to determine the battery con-
dition and voltage, see
BATTERY TEST
Format
XX.X VDC YY
where
XX.X is the measured battery voltage in VDC (nominal 12.6 - 14.6 Vdc).
VDC: DC volts
Y is the information suffix:
C: external AC charger connected.
L: Battery is low (less than 11.4 volts).
CL: Charger is connected and battery is low.
Battery Fuse
The battery inline fuse holder is part of the battery assembly cable attached to the battery pos-
itive terminal. To remove the fuse, twist the buse holder top cap and remove.
Fuse Type: Inline 10 Amp slow blow fuse, .25" diameter
Experience Series 800 Line EFX
Hardware Validation Diagnostic Tests
5 Replacement Procedures
Battery Replacement
(51765761).
44