P10, P20, And P30 Consoles; P62, P80, And P82 Consoles - Precor Experience Series 800 line EFX Service Manual

The Information Display menu provides information about the machine usage, software, main-
tenance, and the error event code log.

P10, P20, and P30 consoles

METRIC
ODOMETER
HOUR METER
(2)
BELT RATING
MAINT COUNTER
U-BOOT SW
U-BASE SW
METRICS BOARD SW
L-MAJOR SW
L-MINOR SW
L-ASL SW
SER NUMBER
USAGE LOG
"Error Log & Event Log" on
page 131
(1) Only available on ASL equipped models.
(2) TRM800-14, TRM700-16 models

P62, P80, and P82 consoles

Experience Series 800 Line EFX
The total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
Displays the belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding down QuickStart.
Hours remaining until maintenance is required (initializes
to 250 hrs, approximately 1 month use).
Press/Hold the PAUSE/RESET key to reset the counter.
The console Upper Boot software version information.
The console Upper Base software version information.
The console Metrics board software version information
The LPCA Major processor software version information.
The LPCA Minor processor software version information.
Note: The Minor software versions can only be viewed
while the user is pedaling. If the user is NOT pedaling, then
the software will be displayed as "--------------".
The LPCA Active Status Light processor software version
information.
Displays the model and serial number of the machine. The
base serial number can be set using the WinCSAFE com-
puter software. The factory default is NONE.
Displays the type of workout programs the users are
accessing most frequently.
Table of stored error event codes.
TIP: You can quickly access the Error log by holding down
the PAUSE key. Will show the STUCK KEY message
when there are no logged error codes.
3 Standard Service and Diagnostics Menus
Information Display (65)
DESCRIPTION
29