Show Lldp Configuration - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide

44.21 show lldp configuration

Use the show lldp configuration Privileged EXEC mode command to display the
LLDP configuration for all ports or for a specific port.
Syntax
show lldp configuration
Parameters
interface-id—Specifies the port ID.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Examples
Example 1 - Display LLDP configuration for all ports.
Switch# show lldp configuration
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Notifications interval: 5 seconds
LLDP packets handling: Filtering
Port State Optional TLVs
-------- ----- --------------
gi1 RX,TX PD, SN, SD, SC
gi2 TX PD, SN
gi3 RX,TX PD, SN, SD, SC
[interface-id]
Address
-------
172.16.1.1
172.16.1.1
None
Notifications
------------
Disabled
Disabled
Disabled
44
666